Page 2
SPECIFICATION RW-2016 ISSUE 8
6.2
Tensile Strength and Ultimate Elongation
The test method shall be as specified in ASTM D 638.
For tubing of recovered inside diameter greater than 6.0 mm (0.236 inch), five Type IV dumbbell specimens shall be
tested. For tubing of recovered inside diameter less than or equal to 6.0 mm (0.236 inch), five tubular specimens
150 mm (6 inches) long shall be tested. Rate of jaw separation shall be 500 ± 10 mm (20 ± 0.5 inches) per minute.
The test shall be carried out at a temperature of 23 ± 2 ° C.
6.3
Halogen Content
Determine the halogen content (fluorine, chlorine and bromine) of tubing by any suitable elemental analysis technique
capable of measuring each halogen to ± 50 ppm or all three halogens together to ± 100 ppm.
7.
7.1
7.2
7.3
8.
8.1
PREPARATION FOR DELIVERY
Form
The tubing shall be supplied in cut lengths unless otherwise specified.
Packaging
Packaging shall be in accordance with good commercial practice.
Marking
Each container of tubing shall be permanently and legibly marked with the size, quantity, manufacturer's identification
and batch number .
APPLICABLE DOCUMENTS
This specification takes precedence over documents referenced herein. Unless otherwise specified, the latest issue of
referenced documents applies. The following documents form a part of this specification to the extent specified herein.
GOVERNMENT FURNISHED DOCUMENTS
Military
MIL-H-5606
MIL-DTL-83133
MIL-C-24643
NES 711
NES 713
Hydraulic Fluid, Petroleum Base, Aircraft, Missile and Ordnance
Turbine Fuel, Aviation, Grade JP-8
Cable and Cords Electrical Low Smoke for Shipboard Use, General Specification
Determination of the Smoke Index of the Products of Combustion from Small Specimens of
Material
Determination of the Toxicity Index of the Products of Combustion from Small Specimens of
Material
8.2
OTHER PUBLICATIONS
American Society for Testing and Materials (ASTM)
ASTM D 570
ASTM D 638
ASTM D 792
ASTM D 876
ASTM D 2671
Standard Test Method for Water Absorption
Standard Test Methods for Tensile Properties of Plastics
Standard Test Methods for Specific Gravity (Relative Density) and Density of Plastic
by Displacement
Standard Test Methods for Non Rigid Vinyl Chloride Polymer Tubing Used for Electrical
Insulation
Standard Methods of Testing Heat-Shrinkable Tubing for Electrical Use
If this document is printed it becomes uncontrolled. Check the latest revision.
? 2007-2008 Tyco Electronics Corporation. All rights reserved
相关PDF资料
CBA-NF-NM1 CABLE ASSY N MALE-N FEM 1000MM
CBA-NM-NM1 CABLE ASSY N MALE-N MALE 1000MM
CBA-SMA-FME1 CABLE ASSY SMA F-FME F 100MM
CBA-SMA-MMCXRA CABLE ASSY SMA F-MMCX M RA 100MM
CBA-SMA-SMA18 CBL ASSY SMA M-SMA M REV 1800MM
CBA-SMA-SMB1 CABLE ASSY SMA F-SMB F 100MM
CBA-SMAM-NM1 CBL ASSY N MALE-SMA M REV 1000MM
CC-5190 CABLE CARRIER ASSEMBLY
相关代理商/技术参数
CB5442-000 功能描述:热收缩管和套管 XFFR-20X25 RoHS:否 制造商:3M Electronic Specialty 类型:Tubing 材料:Polyolefin, Flexible 颜色:Clear 最低收缩温度:+ 100 C 恢复直径: 长度:100 ft 内径:1.5 in 收缩率:2:1
CB5443-000 功能描述:热收缩管和套管 XFFR-20X4 RoHS:否 制造商:3M Electronic Specialty 类型:Tubing 材料:Polyolefin, Flexible 颜色:Clear 最低收缩温度:+ 100 C 恢复直径: 长度:100 ft 内径:1.5 in 收缩率:2:1
CB5444-000 功能描述:热收缩管和套管 XFFR-30X25 RoHS:否 制造商:3M Electronic Specialty 类型:Tubing 材料:Polyolefin, Flexible 颜色:Clear 最低收缩温度:+ 100 C 恢复直径: 长度:100 ft 内径:1.5 in 收缩率:2:1
CB5445-000 功能描述:热收缩管和套管 XFFR-30X4 RoHS:否 制造商:3M Electronic Specialty 类型:Tubing 材料:Polyolefin, Flexible 颜色:Clear 最低收缩温度:+ 100 C 恢复直径: 长度:100 ft 内径:1.5 in 收缩率:2:1
CB5446-000 功能描述:热收缩管和套管 XFFR-40X4 RoHS:否 制造商:3M Electronic Specialty 类型:Tubing 材料:Polyolefin, Flexible 颜色:Clear 最低收缩温度:+ 100 C 恢复直径: 长度:100 ft 内径:1.5 in 收缩率:2:1
CB5447-000 功能描述:热收缩管和套管 XFFR-48-15/97 CB5364-000 RoHS:否 制造商:3M Electronic Specialty 类型:Tubing 材料:Polyolefin, Flexible 颜色:Clear 最低收缩温度:+ 100 C 恢复直径: 长度:100 ft 内径:1.5 in 收缩率:2:1
CB5448-000 功能描述:热收缩管和套管 XFFR-48-20/97 RoHS:否 制造商:3M Electronic Specialty 类型:Tubing 材料:Polyolefin, Flexible 颜色:Clear 最低收缩温度:+ 100 C 恢复直径: 长度:100 ft 内径:1.5 in 收缩率:2:1
CB5449-000 功能描述:热收缩管和套管 XFFR-48-40/97 RoHS:否 制造商:3M Electronic Specialty 类型:Tubing 材料:Polyolefin, Flexible 颜色:Clear 最低收缩温度:+ 100 C 恢复直径: 长度:100 ft 内径:1.5 in 收缩率:2:1